Car Kit Bluetooth
®
SIM (en)
4
Direct installation of the display
First clean the area where you
want to attach the display
6
using a grease-dissolving clean-
ing agent. The adhesive pad will
only adhere permanently to a
grease-free surface.
Mount the display
6
using the
adhesive pads.
Installation using the display holder
The display holder
7
allows you
to mount the display
6
in the
various positions specified in the
diagram (see bottom right on
page iv).
The cable must be fed through
the display holder
7
in the ap-
propriate position. To this end,
notches must be cut into the
case edging at specific points
where the wall thickness is
recognisably thinner.
Mount the display holder
7
on-
to the dashboard using the
adhesive pads supplied or the
appropriate screws*.
Then press the display
6
into
the opening on the display
holder
7
until it clicks into
place.
Loudspeaker
The inclination and the rotation
of the loudspeaker
8
can be ad-
justed. Loosen the set screw in
the base, install the loud
speaker
8
, and tighten the
screw.
Secure the loud speaker
8
in an
appropriate location (e.g. the
passenger footwell).
The screws can be found in the
base of the loud speaker
8
.
Wiring loom
Electrical connections
When connecting the Car Kit to
the wiring loom
3
, make sure
the functionality and operation
of other devices are not compro-
mised (e.g. voltage drop).
Disconnect the car battery cor-
rectly before installing the wir-
ing loom
3
and the electronics
box
1
.
Connect the
§B§
12 V+ cable (red)
to the positive terminal of the
car battery.
* Not included in standard delivery.