Benq DC 2110 User’s Manual
3
2. P
REPARING
YOUR
DC 2110
FOR
USING
2.1. Installing batteries and memory card
Follow the steps below to install battery and memory card.
If an AC adapter is used:
1. Make sure the AC adapter is 3V/2.0A.
2. Plug the AC adapter into the DC Power Terminal.
Note
• Batteries may lose electricity power if kept inside the camera for a long time without using.
Please remove the batteries if the batteries are expected not to be in use for a long period.
• Do not use manganese batteries as they cannot supply sufficient power to support the
camera's operations.
• Batteries may not be able to work normally under 0
o
C.
• Please avoid using the TFT LCD Monitor if possible. Using TFT LCD Monitor will need
considerable electricity power which may drain the batteries sooner than expected.
• Do not mix to use old and new or different types of batteries.
• It is normal that the temperature of the camera body rises when used for a long period.
• It is suggested to use an AC adapter if you expect to use the camera for a long period.
• Please make sure the AC adapter meets the specification requirement which is 3V/2.0A.
• Please make sure to switch off the power first before you unplug the AC adapter from the
camera.
If batteries are used:
1. Open the Battery Cover.
2. Load the batteries into the battery
chamber following the polarity
indic,
_
).
3. Close the Battery Cover until
you hear a click sound.
Note
On the LCD Panel you can see the battery status as below:
(
) Batteries are with sufficient electricity power to support the camera's operations.
(
) Batteries are about to drain soon. Please prepare new batteries.
(
) Batteries drained. Replace with new batteries.