2
English
3. Open the battery compartment cover at the bottom of the
wireless controller and insert the three AAA batteries
provided (please make sure that the batteries are inserted with
the correct polarity) and then install the battery cover back.
• Do not mix old and new batteries.
• Do not place the batteries under direct sunlight, at a high
temperature or near fire. Neither store the batteries in high
humidity nor submerge them in water.
• Do not disassemble, hit, or make modifications to the batteries
or they may short circuit and pose a hazard.
• Do not attempt to recharge discarded non-chargeable batteries
or expose them to fire.
• Remove the batteries if they are depleted or if the lamp will not be used for an extended
period; otherwise chemicals inside the batteries may leak and damage the product.
• To reduce adverse impact on the environment and prevent health hazards, please properly
discard the batteries according to your local recycling regulations.
How to Use
Activating the Wireless Controller Before Use
Turning On/Off the Lamp and Switching Light Modes
Power On/Off
Light Mode Control
Auto Dimming Mode
3
The wireless controller will enter sleep mode after 5 seconds idle to save
power. To activate the wireless controller, place your hand 2 cm above the
sensor on the wireless controller. The power indicator
in the
center of the wireless controller will then light up to indicate that you can
start performing operations.
• The wireless controller can be operated within 1 meter of the lamp.
• When the wireless controller is in the sleep mode, the power
indicator
located in the center of the wireless controller will
turn off.
Tap the
Power
button to turn on the lamp. To turn off the lamp, tap the
Power
button again.
When the remaining battery charge is low, the power indicator will flash
to remind you to replace the batteries.
Tap the
Light Mode Switch
button to cycle through the following three
light modes:
Front light on
>
Ambient light on
>
Both lights on
Tap the
Auto Dimming Mode
button
to enter this mode. The indicator
will light up when the mode is on. In the Auto Dimming Mode, the light mode
(front light/ambient light/both) remains the same while the lamp automatically
adjusts its brightness according to the surrounding lighting condition and sets
the color temperature to 4000K.
• Avoid blocking the light sensor located on the lamp
to ensure that the Auto Dimming Mode works
correctly.
• The Auto Dimming Mode will automatically turn off
when you adjust the brightness or the color
temperature or switching light modes. The Auto
Dimming Indicator will turn off when the mode is off.
Summary of Contents for CR20 C
