1.1 General notes
Introduction
5190 / 04/2021 en
BENNING TA 6
6
1
Introduction
The BENNING TA 6 measuring adapter described here (in the following only referred to as
“device”) is an optional accessory for the BENNING IT 115, IT 130 and IT 200 installation
testers. The BENNING TA 6 measuring adapter enables you to perform tests on electrical
installations in compliance with DIN VDE 0100‑600 (IEC 60364‑6) and DIN VDE 0105‑100
(EN 50110) using the corresponding installation tester.
The device ensures safe contact between the BENNING installation tester and the 5-pin 16 A
CEE socket (3P / N / PE, 400 V, 50 Hz) of the electrical installation.
The device supports the following measurements:
• Insulating resistance measurement R
ISO
(L1‑PE, L2‑PE, L3‑PE, N‑PE, L1‑L2, L2‑L3, L3‑L1)
• Loop impedance measurement Z
LOOP
(L1‑PE, L2‑PE, L3‑PE)
• Line impedance measurement Z
LINE
(L1‑N, L2‑N, L3‑N, L1‑L2, L2‑L3, L3‑L1)
• RCD testing
• Phase sequence test, voltage and frequency measurements
Further information
http://tms.benning.de/ta6
On the Internet, you will find the following additional information directly at the specified link or
at www.benning.de (product search):
• Operating manual of the device in several languages
• Further information depending on the device (e. g. brochures, technical reports, FAQs)
1.1
General notes
Target group
This operating manual is intended for the following groups of people:
• Qualified electricians and qualified technical personnel
Required basic knowledge
To understand these operating manual, you will need general knowledge of testing and
measuring equipment. Moreover, you will need basic knowledge of the following issues:
• General electrical engineering
Purpose of the operating manual
This operating manual describes the device and provide you information about how to handle it.
Keep this operating manual in a safe place for later use. Read this operating manual before
handling the device and follow the instructions.
