beneq Lumineq EL240.128.45 Series, Operation Manual

Page: 7 / 18

Operation Manual
EL240.128.45 Display
Beneq Oy
Olarinluoma 9 Tel. +358 9 7599 530 VAT ID FI19563372
FI-02200 Espoo Fax +358 9 7599 5310 www.beneq.com
Finland lumineq@beneq.com www.lumineq.com
Date: February 13, 2017 Document number: ED000810B Page | 7
3.2 Connector
Video signals and DC power are supplied to the display through a single 24-pin, dual-row, 2
mm pitch square pin, right-angle, locking connector, such as Samtec part number EHT-112-
01-S-D-RA, or an equivalent connector matching the pin outs in Table 3. The mating
connector is the Samtec TCSD family of cable strips. Consult your Samtec representative for
cable and connector options.
Figure 2. Data/power connector – J1
Table 3. Connector pinouts J1
Pin Signal Description Pin Signal Description
1 V
H
Display voltage 2 V
H
(+12 V)
3 GND Ground 4 GND Ground
5 V
L
(+5 V)
Vv)V)V)
Logic voltage 6 RES Reset
7 /WR Write 8 /RD Read
9 /CS Chip Select 10 A0 Address
11 SELFTEST 12 GND Ground
13 D0 input/output 14 D1 input/output
15 D2 input/output 16 D3 input/output
17 D4 input/output 18 D5 input/output
19 D6 input/output 20 D7 input/output
21 SEL1 Select Interface 22 READY Display ready output
23 GND Ground 24 LUMA Luminance control
J1
Pin 1
(Back of display)
(Bottom of display)
(Viewed from top of connector)