Page 3 of 3
Assembling
1. Slide the element (2) into the element (1) 200mm, and then secure worm clamp.
2. Slide out the element (3) from the element (2) until all 3 holes of both elements can be seen together.
Using tapping screws (M5 x 8), tighten both elements.
3. Slide out the element (4) from the element (3) until 2 holes of both elements can be seen together.
Using tapping screws (M4 x 8), tighten both elements.
4. Slide out the element (5) from the element (4). Then slide it again into the element (4) 100mm, tighten
them with a pair of screw sets.
5. Using the supplied U bolts, washer and nuts, tighten them against your mast.
6. Connect 50 ohms coaxial cable with a PL-259 connector to the antenna connector’s matching section.
Tape over the connector with a supplied self adhesive tape.
Antenna Assembling Diagram
