RBJ Series of Rolling Jacks
6
P/N 5900004 — Rev. D1 — October 2020
Components
Rolling Bridge Jack components include:
•
Scissor Structure
. Rolling Bridge Jacks are scissor lifts that are powered by air pressure from
the Air-Operated Hydraulic Pump.
•
Air-Operated Hydraulic Pump
. Provides hydraulic power to the Rolling Bridge Jack. The Air-
Operated Hydraulic Pump must be attached to a dry air supply: 20 cubic feet per minute (.57 cubic
meters per minute) and 100 psi (7 bar).
•
Hydraulic Hose
. Connects the Air-Operated Hydraulic Pump to the Hydraulic Cylinder. Comes
connected from the factory.
•
Hydraulic Cylinder
. Moves the Scissor Structure up and down.
•
Safety Locks
. Hold the Rolling Bridge Jack in place once engaged at the desired height (two
heights available). Always leave your Rolling Bridge Jack either fully lowered or engaged on its
Safety Locks.
Do not leave a Rolling Bridge Jack in an unlocked position with a
Vehicle on it
.
⚠
WARNING
Before starting work on a Vehicle, make sure the Rolling Bridge Jack is engaged on
its Safety Locks and the Pads are in contact with the axle on the underside of the
Vehicle.
•
Safety Handle
. Moves the Rolling Bridge Jack off its Safety Locks so it can be lowered.
Not the
same as the Handle you use to move the Rolling Bridge Jack
.
•
Adjustable Arms
. Slide in and out so you can use the Fixed Pads at appropriate locations under
the Vehicle.
•
Receiver Plate
. Holds the Sliding Pads on the outside and the Adjustable Arms on the inside.
Part of the structure of the Rolling Bridge Jack.
•
Fixed Pads
. Steel Pads that go on the ends of the Adjustable Arms. All three Rolling Bridge
Jacks come with two sets of Fixed Pads.
•
Sliding Pads
. Steel Pads that slide over the Receiver Plate and can be used anywhere along it.
All three Rolling Bridge Jacks come with two sets of Sliding Pads.
•
Handles
(2). Used to move the Rolling Bridge Jack.
Not the same as the Safety Handle
.
•
Extendable Bases
. Move in and out to accommodate the distance between the Lift’s Runways.
Only the RBJ15000 has Extendable Bases.
•
Channel Rollers
. Located on the ends of the Bases, the Channel Rollers sit in the Utility Rail
Channel and let you move the Rolling Bridge Jack along the Utility Rail.
•
Adjustment Bolts
. RBJ15000 only. A safety feature, they hold the Extendable Bases in place.
Installed after the RBJ15000 is moved into place.
Installation is mandatory
.
Summary of Contents for RBJ15000
