BendPak 5175183, Service Manual

Page: 45 / 55

5
1
6
7
4
3
9
2
8
5
11
10
12
13
NEXT ASSEMBLY
5215779
ITEM
NO.
PART
NUMBER
DESCRIPTION QTY. REV
1 5701336 XR-12000L LEFT HAND RAMP 1 E
2 5701334 XR-12000L SLIDE BLOCK RAIL 2 C
3 5761088 XR-12000 SERIES RAMP PIN LOCK 4 C
4 5700213 XR-12000L ROLLING JACK RAIL 1 D
5 5620453 XR-12000 SERIES FRONT TIRE STOP WELDMENT 1 A
6 5736346 XR-12000 SERIES REAR RAMP END PLATE 1 A
7 5735032 ROLLING JACK RAIL CLOSEOUT 2 C
8 5761089 XR-12000 SERIES SHORT HOSE RETAINER 2 B
9 5765110 XR-12000 SERIES LONG HOSE RETAINER 1 C
10 5735309 XR-12000L INSIDE RAMP STRAP 1 C
11 5735310 XR-12000L OUTSIDE RAMP STRAP 1 C
12 5735386 XR-12000 SERIES RAMP STOP, FRONT 2 B
13 5735382 XR-12000 SERIES RAMP STOP 2 B
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
A PRODUCTION RELEASE, DERIVED FROM 5600530 04/30/2018 TS 00919
SHEET 1 OF 5
REV DWG. NO.
A
SIZE
TITLE:
NAME DATE
CHECKED
DRAWN
A
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
NOTE: UNLESS OTHERWISE SPECIFIED.
TS
5601257
XR-12000L LEFT HAND
RAMP WELDMENT VER C
04/30/2018
DO NOT SCALE DRAWING
1:30 SCALE:
THIRD ANGLE PROJECTION
CA 7/19/2018
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 1.
REMOVE ALL WELD SPLATTER 2.
DIMENSIONS SHOWN ARE AFTER PAINTING 3.
PAINT BENDPAK GRAY (RAL-7024) 4.
APPLY #30 GRIT ALUMINUM OXIDE WHEN 5.
PAINTING TO TOP ONLY AFTER WELDING
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
ANGULAR: 0. = 2 °
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED