BendPak 5175164, Service Manual

Page: 28 / 36

1
2
12
11
10
3
4
9
5
7
6 8
13
14
REVISION
REV DESCRIPTION DATE EDITED BY ECO#
F
UPDATED TITLE TO REFLECT WHERE USED, ADDED
6mm WELD pg 4, UPDATED BOM REVISIONS
AND NEXT ASSEMBLIES
09/24/2015 TM 00724
G UPDATED BOM REVISIONS 08/24/2018 CA 00945
H UPDATED BOM REVISION 01/10/2022 TM 01378
ITEM
NO
PART
NUMBER
DESCRIPTION QTY REV
1 5701064 HDS-27X SERIES POWER SIDE RAMP 1 D
2 5736149 HDS-18E/27 RAMP SUPPORT PLATE 4 B
3 5731022 HDS-18E/27 BOTTOM SHEAVE PLATE 2 B
4 5735087 HDS-18E/27 SERIES CYLINDER MOUNTING PLATE 1 C
5 5736151 HDS-18E/27 SERIES CYLINDER MOUNTING BLOCK R.H. 1 B
6 5736152 HDS-18E/27 SERIES CYLINDER MOUNTING BLOCK L.H. 1 B
7 5755034 HDS-27 WIDE AIR SAFETY TROUGH 6 A
8 5700012 HOSE RETAINER 17 B
9 5735016 HDS-18E/27 SERIES CYLINDER STRAP 1 B
10 5731021 HDS-18E/27 SERIES POWER SIDE RAMP END PLATE 2 B
11 5755031 HDS-18/27/40 HINGE TUBE 4 D
12 5735074 HDS-18/27/40 CROSSTUBE SHAFT STOP 2 D
13 5735350 LARGE CYLINDER ALIGNMENT KEY 1 A
14 5736536 HDS-18/27/40 FLEX TUBE NUT PLATE 1 B
NEXT ASSEMBLY
5600141 SHEET 1 OF 4
REV DWG. NO.
A
SIZE
TITLE:
NAME DATE
CHECKED
DRAWN
H
1645 LEMONWOOD DR.
SANTA PAULA, CA 93060
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS
THE SOLE PROPERTY OF BENDPAK INC. ANY
REPRODUCTION IN PART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF BENDPAK INC. IS
PROHIBITED.
GJZ
5620198
HDS-27X POWER SIDE
RAMP WELDMENT
10/21/2008
DO NOT SCALE DRAWING
1:35 SCALE:
THIRD ANGLE PROJECTION
OR 01/11/2022
DIMENSIONS ARE IN MM
TOLERANCES:
0. = ±1.5
0.0 = ±0.5
SURFACE FINISH 1.6 ISO Ra µm
FOR MACHINED SURFACES
UNLESS OTHERWISE SPECIFIED
REFER TO MODEL FOR ADDITIONAL INFORMATION 1.
BREAK AND DEBURR ALL SHARP EDGES 0.3mm 2.
REMOVE ALL WELD SPLATTER 3.
NOTE: UNLESS OTHERWISE SPECIFIED.