BendixKing
AeroPanel 100 Audio Selector Panel
Installation and Operator’s Manual
89000063-011
Page 2-12
Rev. 0, April 2020
2.11.3 Marker Checkout
1.
Connect a ramp generator at the antenna end of the marker coax. With the unit under test in HI sensitivity,
verify that a 160
V, modulated 95% with 1300 Hz, signal will illuminate the amber (M) marker light,
and that marker audio is present in the headphones when the Marker Audio (MKR) push-button has been
depressed. Select SPR for speaker to verify marker audio availability on the cabin speaker. Verify that
the white (I) and blue (O) lights will illuminate within
3dB of the amber lamp, with 3000 HZ and 400
Hz applied, respectively.
2.
Repeat with the unit in LOW sensitivity, with 430
Volts applied.
3.
Connect the marker antenna and verify proper operation.
2.11.4 Bluetooth Checkout
Verify that the AeroPanel 100 will “pair” with a Bluetooth device, and interface with cellular phone and
Music source.
2.11.5 Internal Recorder Checkout- PLAYBACK
With headset plugged into pilot’s side jacks, tune COM 1 to local frequency, such as
FSS or ATC ground. Select Com 1 on mic selector switch, and record several incom-
ing radio transmissions.
Momentarily press the PLAY button on the front panel. This action will then automat-
ically play back the last recorded message. Momentarily press the PLAY button again to stop the play back,
and then momentarily press again to play prior messages.
This audio should appear in the pilot and copilot headsets, and only be incoming transmissions from the
transceiver selected in the mic select switch.
Depress the audio panels yoke mounted playback switch (hardwire), and verify that messages play, in the
order received. Repeat for COM 2 The playback will be stopped by audio on the selected com. The mes-
sage can be replayed from the beginning, and audio received during the playback will not be stored.
2.12 Final Inspection
Verify that the wiring is bundled away from all controls and no part of the installation interferes with aircraft
control operation. Move all controls through their full range while examining the installation to see that no
mechanical interference exists. Verify that the cables are secured to the aircraft structure in accordance with
good practices, with adequate strain relief. Ensure that there are no kinks or sharp bends in the cables and
coaxial cables. Verify that the cables are not exposed to any sharp edges or rough surfaces, and that all contact
points are protected from abrasion.
Complete documentation that may be required, such as a logbook entry, weight and balance computation and
FAA Form 337. Sample text for FAA Form 337, and instructions for continuing airworthiness can be found
in Appendix F. Return completed warranty registration application to BendixKing.
.
