Safety instructions
12
isoPV_D00024_02_M_XXEN/07.2018
2.3.1
Personnel
Only appropriately qualified personnel may work on the ISOMETER®. Qualified means
familiar with the installation, commissioning and operation of the product and with
training appropriate to the work. Personnel must have read and understood the safety
section and warning information in this operating manual.
2.3.2
Hazards when handling the ISOMETER® isoPV
The ISOMETER® is constructed according to the state-of-the-art and the recognised
technical safety rules. Nevertheless, when it is being used, hazards may occur to the life
and limb of the user or third parties or there may be adverse effects on the
ISOMETER
®
or on other valuable property. Only use the ISOMETER®:
•
within the scope of its intended use
•
in perfect working order
Any faults which may impair safety must be eliminated immediately. Impermissible mo-
difications and the use of spare parts and additional devices which are not sold and re-
commended by the manufacturer of the devices may cause fires, electric shocks and
injuries.
Unauthorised persons must not have access to or contact with the ISOMETER
®
.
Warning signs must always be easily legible.
Damaged or illegible signs must be replaced immediately.
In order to meet the requirements of the applicable standards, customised parameter
settings must be made on the equipment in order to adapt it to local equipment and
operating conditions. Please heed the limits of the range of application indicated in the
technical data.
Any use other than that described in this manual is regarded as improper.
2.3.3
Note
Make sure that the operating voltage is correct!
Prior to insulation and voltage tests, the ISOMETER
®
must be disconnected from the po-
wer system for the duration of these tests.
In order to check the proper connection of the device, it is recommended to carry out a
functional test.
Make sure that the basic settings meet the requirements of the IT system.
Children and unauthorised persons must not have access to or contact with the
ISOMETER
®
.
Summary of Contents for ISOMETER isoPV with AGH-PV
