Bender COMTRAXX CP9 Series, Manual

Page: 19 / 36

CP9xx-x_D00406_00_M_XXEN/04.2020 19
COMTRAXX® CP9xx-x – Control Panel
3 Mounting and connection
3.1 Mechanical installation
3.1.1 General description
The mechanical design of the enclosure for flush mounting with bezel frame is oriented toward
longevity and particularly suited for the high hygienic requirements in medical locations. The en-
closures are all custom made to suite the technical and mechanical requirements on site.
The actual flush-mounting enclosure is made of stiff, grey 4 mm PVC plastic or 3 mm aluminium
with an extruded aluminium profile of natural aluminium colour.
The bezel frame covers a gap of up to 13 mm. Please refer to the chapter „3.2.1 Mounting a
flush-mounting enclosure with bezel frame enclosure“ for more information
The size of the circular gap between the bezel frame and the front plate is 0.5 mm.
The front plate features a concealed seal to offer the highest possible level of protection.
The front plate is attached to the bezel frame with concealed hinges. The location of the hinges
are according to the individual elevation illustrations.
CP9xx-G alarm indicator and operator panels have a glass front plate without hinges. The glass
front plate is retained in the enclosure by a snap-in mechanism.
I
C
aution
! Damage to the glass front plate!
Placing the suction lifter in the middle and pulling only at this point may damage the glass
front plate.
The necessary PCBs and components are attached to the front plate using bolts. Other electrical
components are connected to the components located on the mounting plate via a flexible hose.
The mounting plate can be easily removed from the flush-mounting enclosure to install it. The ca-
ble connections between the front plate and the mounting plate do not need to be disconnected.
Since no other components are attached to the rear side of the enclosure except for the mount-
ing plate, the technician has sufficient space for installation.
Please observe chapter „3.2 Mounting instructions“ and chapter „3.3 Fastening, cable entry“.