Bender A-ISOMETER AGH575S-6, Operating Manual

Page: 35 / 60

Operation and setting
35 TGH1384en/06.2005
4.6 Menu COM SETUP: Setting the BMS interface
4.6.1 Bus address „Addr:“
This menu item is used to set the BMS bus address of the A-ISOMETER®.
Since there are several A-ISOMETERs in one system, take care that the bus
address is not assigned twice.
The device is factory set to address 3 and hence acts as a slave.
4.6.2 Diagram COM SETUP
If several A-ISOMETER® s are operated on one BMS bus, the addresses
of other A-ISOMETER® s must be assigned one after the other, since
only one device may represent the Master.
1. EXIT
2. HISTORY INFO
3. ISO SETUP
4. ISO ADVANCED
5. COM SETUP
6. PASSWORD
7. LANGUAGE
8. SERVICE
1. Exit
2. Addr: 003 Addr : 003
ADR: 001
.
.
.
ADR: 030
*** IT-SYSTEM ***
R >010 M W H