9
OPERATING INSTRUCTIONS
Using the screw supplied with the
accessory guide, position as shown in
Figure 5 and thread the screw into the
shoe to clamp the fence securely.
When circle cutting, adjust rip fence so
that distance from blade to hole in cross
bar is at the desired radius and tighten
screw (use hole which lines up best with
saw blade). Place saw so that hole in
cross bar is over center of circle to be
cut (make pocket cut, drill hole for blade
or cut inward from edge of material to
get blade into position). When saw is
properly positioned, drive a small nail
through hole in cross bar. Using rip
fence as a pivot arm, begin cutting
circle. For circle cutting, the cross bar
should be up, as shown in Figure 5.
When ripping, slide the rip fence under
the screw from either side of the saw.
Set the cross bar at desired distance
from blade and tighten screw. For
ripping, the cross bar should be down
and against the straight edge of the
workpiece.
TM
TM
OPERATING INSTRUCTIONS
ACCESSORIES
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside
the tool; never immerse any part of the tool into a liquid.
MAINTENANCE
Kmart has a large selection of acces-
sories for your Jig Saw for most any job
application around the home or in your
workshop.
CAUTION:
Never use acces-
sories in your jig saw that are not
designed for use in your jig saw.
They may be hazardous and may
present a risk of injury to operator.
5
389997 -00/BT400 Jig Saw 11/3/03 2:49 PM Page 9
