16
CH heat output setting :
If you would like to change the setting of the C.H. heat output, please proceed as follows :
(Note: the factory setting is 18 kW and the following explanation refer to menu 4 section 9)
- Switch to the installer mode, press
both the
and
keys on the
DHW side for 5 seconds.
The display shows :
-1- then 0
•
-- if there is no default in the
default register.
- press the menu key 3 times
(on
CH side ) to gain access to menu
-4-,
The display shows :
-4- then the value set for section 0 ( 00
or 01 respectively Action on burner only
or pump and burner)
- change to Section 9 (Adjustment of
C.H. heat output). Press the
key
on the DHW side times.
The display shows :
(
906 which corresponds to 18 kW
which is the factory setting)
9 = section 9 06 = 18 kW
- press the setting key
(on CH
side) once, the 2nd and 3rd digits flash
together. Then press the
or
key on the DHW side to change the
C.H. heat output step between
00 and
10.
Press the setting key to confirm the
value. The display stops flashing. The
setting procedure is finished.
To exit from the setting mode, leave the
boiler for approx. 1 minute, the boiler
will then revert to the user mode.
After programming please close the
door
P (Fig. 18)
1
Display
2
x 3
1
2
or
3
3
x 9
4
4
5 ”
9
Adjustments and Settings
(continued)
