Benchmark Scientific Accuris, Instruction Manual, Page: 4 / 60

4
Safety instruction
READ ALL INSTRUCTION BEFORE USE
Caution
• Check the power supply input voltage and make sure it matches the wall outlet voltage.
• Check that the power cable is connected to a grounded, 3-pin wall outlet.
• Check that the power cable is properly grounded to avoid potential electrical shock.
• Check that the main power switch is off when plugging in the power cable to the wall outlet or
when unplugging the power cable.
• Power on using the main switch on the rear panel, wait about 2-3 minutes for the device to reboot.
• Do not insert any metallic objects into the device through backside air vent to avoid electrical shock
causing personal injury or device damage.
• Place the device in an area where there is 10 cm clearance from other objects to allow for proper
air-cooling.
• Do not disassemble the device. If service is needed, contact Accuris Instruments or an authorized
distributor.
• Use authorized accessories only.
• Operator should have the general knowledge of laboratory techniques and cell counting
procedures as well as safe handling of biological samples.
• Operate the device carefully as described in this manual.
Warning
• Battery
There is a Lithium battery is inside the device. Replacing it with an incorrect type can cause risk of
explosion. This battery should not be replaced by the user; contact Accuris an authorized service
center if required.
• Sample handling
Samples may contain infectious biohazardous substances. Operator should wear gloves while
handling all samples.
• Waste
Dispose used QuadCount™ Slides as biohazardous waste and do not reuse them.