13
o
If the straight edges rests on the wheel and are equal distant to the center of
the hole on the wheel, then the Ball drop Assembly is correctly aligned as
shown below on the left side.
o
If the straight edges are not equal distant to the center of the hole on the
wheel, as shown below on the right, then the Ball Drop Assembly needs to be
adjusted.
o
Grab a Philips head screw driver (P2),
preferably with a neck longer than 9”.
o
Slightly loosen the two
screws which lock the Ball
Drop Assembly in place in
the
red
circles, as shown
to the right.
o
Shift the Ball Drop
Assembly in the direction
in which will align the
opening with the
corresponding hole on the
playfield.
o
Use the two straight
edges to confirm that the
Ball Drop Assembly is in
the correct position
before tightening the two
screws to fasten in place.
Summary of Contents for Monster Drop Chaos
