Bench Dogs Carpenter Square, Instruction Manual, Page: 3 / 6

CONTACT@BENCHDOGS.CO.UK WWW.BENCHDOGS.CO.UK Q E M
FOR MORE INFORMATION PLEASE VISIT
Place the carpenter square so the cheek
is touching the side of your sheet. Using
either the straight or diaganol edge,
make your markings at either 90°
or at 45°.
Using the supplied alignment pins, screw
the first pin (RED) in the hole marked
‘PIVOT’ and the second pin (YELLOW)
in the hole marked with your
desired angle.
Turn over your carpenter square and
place so the alignment pins are touching
the edge of your sheet. Make your
markings at either 5, 10, 15, 20, 22.5,
25, 30, 35, 40 or 45° by adjusting the
second pin (YELLOW)
STEP 1
STEP 1 STEP 2
ANGLED MARKINGS 90° & 45° MARKINGS
90°
45°