4
8.
Place the Back Panel (6) onto the cabinet.
Note the orientation of the dust port and
cord cut-outs in
Fig. 6.
All steel cross-dowel
holes are located
inside
the cabinet. Use ten
1/4-20 x 2" round head bolts (13) and ten
steel cross dowels (19) to secure the panel.
Note:
Some of the cross dowels will be
easier to install by positioning the cabinet
upside down.
9.
Install a Guide Rail (25) to the Left and
Right Side Panels (4 & 5), using four #6 x 3/4"
flat head screws (16). These white nylon guide
rails are used for holding the pull-out router bit
storage trays.
Note:
Position the flat and straight side of
the guide rail up. Also, there is a left and
right orientation.
10.
Install Guide Rails (25) to the Router Bit
Storage Divider Panels (7 & 8), using four
#6 x 3/4" flat head screws (16). Begin by laying
out the panels, as shown in
Fig. 7.
Make sure
the "L" and "R" markings are right-side-up.
Note:
There are left and right rails. Be sure
the flat side of the rail is "up".
11.
Install the Left and Right Bit Divider Panels
(7 & 8), as shown in
Fig. 8.
The divider
panel marked "R" opposes the right side
panel marked "R", and the divider panel
marked "L" opposes the left side panel
marked "L". Use six 1/4-20 x 2" bolts (13)
and six steel cross dowels (19).
12.
Install two Wood Dowels (24) into the front
of the divider panels, do not glue the dowels.
13.
Attach the Header (9) to the cabinet with
four 1/4-20 x 2" bolts (13) and four cross
dowels (19).
Fig. 9.
14.
Attach the center-door Hinge Baseplates (28) to
the cabinet as shown in
Fig. 10.
The plate
resembles a cross. Position the top of the cross
nearest the front edge of the cabinet. The
release tab points to the back panel.
C
ABINET ASSEMBL
Y
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
6
8
7
25
9
28
