S.p.A.
F 1900
6
•
For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the motor
manual provided.
•
NB: To unscrew the oil drain plug of the motor, disassemble the rear cover (Fig. 8 Ref. B).
•
Make a regular check of the oil level in the gearbox with the cap (Fig. 5 Ref. A) and topping up if necessary.
•
Change the oil completely every 200 hours. Empty the gearbox of oil by unscrewing the oil drain plug (Fig. 5 Ref. C)
•
Let the oil drain completely. After screwing back the cap tightly, fill to the correct level with new oil recommended by the
manufacturer. Fig. 5 Ref. "A".
•
If the grass is not cut in a satisfactory manner despite the adjustments, the blade must be sharpened or replaced. For
replacement as follows :
1. Remove the cable of motor spark plug.
2. Put on a pair of gloves.
3. Unscrew the grass divider (Fig.1 - Ref. “6”).
4. Loosen the 4 knife holder.
5. Remove the blade and put the new or the sharpened one, only after having greased it.
6. Rescrew the knife holder, adjusting them in such a way as the blade can slide well.
7. Fasten the grass divider and reapply the cable of the spark plug
Fasten the grass divider and reapply the cable of the spark plug
•
For any mechanical repair, especially during the warranty period, we recommend to go to a specialised repair shop of the
dealer.
•
For transporting convenience, the handles can be disassembled by means of the two knobs (Fig. 8 Ref. A). The same is
recommended for the cutting bar, which is easily disassembled by removing the special split pin on the bar support (Fig. 9).
Always use gloves and apply the protective strip to the blade.
•
Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support
CAUTION
It is advised not to keep the motor running when the machine is not
being used for its specific purpose
.
The machines and accessories are guaranteed for 2 YEARS, with the exception of electrical parts or parts in rubber. The
manufacturer shall replace pieces recognised as defective free of charge. Labour and transport shall be at the expense of the
purchaser. Warranty requests must be made through dealers authorised by the manufacturer.
With regard to materials not of our manufacture, with special reference to the motor, the rules laid down by the respective
manufacturers shall apply. Any requests for repair shall therefore be directed to the specific service centres in the respective
areas.
For any problem or repair, contact the dealer where the machine was purchased.
