Benassi F 170, Use And Maintenance Instruction

Page: 10 / 15

F170
39
SECURITY TERMS
•
Read carefully the operation and maintenance manual enclosed with the machine.
•
The use of the machine is prohibited to persons under 16 years of age.
•
The operator is liable for damages since the machine is under his control.
•
Those unfamiliar with the machine or who have never used it are obliged to read the operation and maintenance
manual before operation.
•
In case of transport, disassemble the bar and empty the petrol out of the tank.
•
If the machine is left unattended, ensure that it cannot start up again.
•
Before running the machine, the operator must have a 5 meter radius of free space around him.
•
Dry any petrol leaks.
•
Fill up the tank with the motor off. Filling the tank or transferring fuel must always be performed outdoors, away from
flames or heat sources. Do not smoke during this operation.
•
When mowing in mountainous areas or on slopes, mow horizontally and use non-skid equipment on shoes and
wheels.
•
If the blade needs replacement, observe E.S.M. operation and maintenance procedures.
•
If the bar suffers impact, check the condition of the bar before resuming work.
•
Keep feet and hands far away from the cutting bar and all rotating parts.
•
Do not run the motor where exhaust containing carbon monoxide may accumulate.
•
Never use the mower incomplete or without its safety device.
•
Do not assemble/disassemble or clean the cutting bar or other equipment with the motor running.
•
Caution! When the clutch is engaged the cutting bar is always in motion.
•
Caution! Do not mow areas with slopes exceeding 20°.
We will not be held liable for accidents caused by the failure to observe these rules.
STARTING AND STOPPING THE MACHINE
Every time you get ready to start the motor, make a careful check of the following:
•
Make sure that fuel is in the tank.
•
Check the motor oil level: CAUTION: MACHINES OUT OF THE FACTORY DO NOT CONTAIN OIL IN THE MOTOR.
Make sure to add oil up to the level on the dipstick.
•
CONSULT THE OPERATION AND MAINTENANCE MANUAL OF THE MOTOR UNDER "BEFORE START-UP"
•
Check that all safety systems are released and functioning.
•
Make sure that the feed cock of the model with Honda engine GCV135 is on.
•
Start the machine always in the open air and stay at its side.
•
Bring the accelerator hand lever (picture 5) to the "MAX" position, grasp the cord handle (picture 6) and pull it slightly
until you feel some resistance, then pull harder. Make sure that the cord does not return by itself -- accompany it with
your hand.
•
With the motor running, bring the accelerator lever (picture 5) to the middle position To make the machine go forward
squeeze the clutch lever (picture 7 Ref. B) ; if you leave the lever, the machine stops.
•
To move the mower freely forward or back, squeeze the wheel release lever (neutral position) after squeezing the
clutch lever.
•
Make sure that fuel is in the tank.
•
Check the motor oil level: CAUTION: MACHINES OUT OF THE FACTORY DO NOT CONTAIN OIL IN THE MOTOR.
Make sure to add oil up to the level on the dipstick.
•
CONSULT THE OPERATION AND MAINTENANCE MANUAL OF THE MOTOR UNDER "BEFORE START-UP"
•
Check that all safety systems are released and functioning.
•
Make sure that the feed cock of the model with Honda engine GCV135 is on.
•
Start the machine always in the open air and stay at its side.
•
Bring the accelerator hand lever (picture 5) to the "MAX" position, grasp the cord handle (picture 6) and pull it slightly
until you feel some resistance, then pull harder. Make sure that the cord does not return by itself -- accompany it with
your hand.
•
With the motor running, bring the accelerator lever (picture 5) to the middle position To make the machine go forward
squeeze the clutch lever (picture 7 Ref. B) ; if you leave the lever, the machine stops.
•
To move the mower freely forward or back, squeeze the wheel release lever (neutral position) after squeezing the
clutch lever.