5
200811_1
Operation Instructions
continued…
Powering the fire
Press the power button to supply power to all the functions of the fire and put the fire into standby mode, the
current room temperature will be shown on the display.
Press the power button again to turn off all functions
Temperature setting or
Fig 1.
Adjust the temperature to the desired setting (15° to 30° range) using the
Temp + and Temp
–
buttons. The set temperature must be above the room
temperature for the heating function to operate. Fig 1.
Heater Operation
Press the heater button to select 2000W, H2 and a red flame symbol will be
displayed. See Fig 2.
Press the heater button again to select 1000W, this time H1 and an orange
flame will be displayed. See Fig 3.
Press the heater button again to turn the heater off
Fig 2.
Fig 3.
Open Window Function
This appliance has an “Open Window Detection Function”. When the heater
is in operation H1 or H2 and the ambient temperature drops 5° within 10
minutes ECO will appear in the display and the heat function will
automatically turn off.
This means there is a window open or a cold draft coming into the room past
the fire. Close the window and press on the manual control panel or the
remote control to restart the heater. See Fig 4.
Fig 4.
Note
: The unit may emit a slight harmless odour and smoke when first used. This odour and smoke is normal and
is caused by the internal heating parts and will not occur again.
Note
: The below functions can be controlled by either the manual buttons on the fire or the remote control.
Ensure the ON / OFF switch is in the “I” position before trying to operate the fire.
Note
: All previous settings are held in the memory so the next time you power
up the fire it will turn on with the same settings unless power to the unit is lost
Note
: On either heat setting the heat function will turn off when the room
temperature reaches the set temperature. The heater will automatically
restart when the room temperature drops 3° below the set temperature as
detected by the fire unit
Note
: The heater fan will run for approximately 30 seconds after the heat
has been turned off, this is to remove any residual heat and protect the
components from potential overheating.
