8
9
PRE-INSTALLATION
Please be advised that the provided T-Valve
should be installed at the fill valve under the
toilet tank, NOT down at the water supply
coming from the wall.
Inspect your current water supply line that
connects to the toilet tank fill valve to ensure it
is a flexible water supply hose before installing
the ELITE-3. The hose needs to be 7/8” (to
connect to the T-Valve we provided) on one
end and either 3/8” or 1/2”, depending on your
wall valve, on the other end.
If you do not have access to the fill valve under
the toilet tank, contact Bio Bidet Customer
Service at 847.458.2334 and we may be able
to provide alternative fittings.
WARNING
: Use care to avoid cross threading
or over tightening the connection. Over
tightening can cause leaking.
NOTICE
: Observe all local plumbing, electrical
and building codes. This device is designed
for connection to a cold water source with
a pressure of 20-80 psi.
INSTALLATION
1. Remove the existing
toilet seat by locating the
bolts and nuts, typically
under a plastic cover, and
removing them first.
2. Close the water supply
valve and flush the toilet
completely so that there
is little to no water left in
the toilet tank.
3. Disconnect the water
hose from underneath
the toilet tank.
4. Connect the 7/8” T-Valve
to the toilet fill valve
where you just removed
the water hose from.
Make sure the rubber
washer is properly seated
with the narrow side up.
Summary of Contents for bioBidet ELITE-3
Page 1: ...User Manual ELITE 3 ...
