18
U S E R M A N U A L
EN
Electronic version of user manual is available on www.bemi-electronics.com
E-book reader, model CGT, Cognita Touch in manual called “device”
It is mandatory to read this manual before start to using the device.
Maintaining Equipment - Do not expose the device to high (over + 50 ° C), low
(below -10 ° C) temperatures or heat due to, for example, sunlight or other heat
source. It may damage the device. Do not handle the device with wet hands. Do
not use this device while driving or walking. Do not expose the device to cleaning
agents, caustics or other chemicals. Producer does not claim liability for any data
loss, damage caused by inappropriate use/maintenance or any mechanical
damage. Please back up your important material at any time to avoid loss. Do not
press or touch the display panel - navigation on this device is performed with the
use of buttons. The device does not have touch display. Use only authorized
accessories. Prevent the device from falling on the ground or being strongly
impacted. Do not attempt to repair this appliance yourself. In case of damage,
contact authorized service point for check-up or repair. Always disconnect the
product form the power mains before cleaning. The appliance should be
connected to a power supply as per specification in the operating instructions or
as marked on the appliance. The battery is not detachable, do not attempt to
disassemble the battery.
The product is not suitable for children and infants.
Charging - For charging, please use the provided charging cable. The
recommended power adaptor current is 5V, 1A. It takes about 3 hours to fully
charge device. To connect the charging, first connect the micro USB connector of
the charging cable to the device. Then connect its USB 2.0 connector to the power
source. After connecting the device properly, a Changing graphic should appear
on the device screen. Note: if the device was completely discharged then
animation of charging may appear after a few minutes.
Buttons and connectors
1. Back button: short press to back, long press
to back to main menu.
2. Micro USB port. 3.
MicroSD card slot. 4. Power button. 5. Reset
button.
