35
Failure
cause
Solution
Small water flow
Low water pressure
Check the tap water
Filter not replaced in time, beyond the use time
Replace the filter
Unsuitable water temperature
Over consumption of water in a short time
Wait a moment, and water is available again
Corresponding functions not started
Press a corresponding function key to start the function
Water leakage
Pipe not connected properly
Inspect the connector to connect the pipe properly
Water pipe and PE pipe bursting
Replace the water pipe and PE pipe
Electric leakage
Machine in poor contact with ground
Use a socket with earth wire, making the machine grounded
properly
Noisy operation
Not installed steadily or levelled
Place the machine on a steady & solid surface; level the
machine
A few pipes are touching some parts inside the appliance,
thus causing it to vibrate
Adjust the position of pipes, making sure they don’t touch any
other parts
Machine fails to run
Power supply not put through
Switch on power supply
The compressor will not start
Power failure
Check that there is voltage in the plug
The compressor is faulty
Replace it
The water is cold but the
appliance is operating exces-
sively or non-stop
Little ventilation
Replace the appliance away from the wall
The condenser is dirty or covered
Clean the condenser or free it of its obstacles
The room temperature is higher than 40°C
It’s normal that the appliance works at a continuously high
room temperature
troubleshooting
Safety
precautions
Product
introduction
W
orking
principle
Using the product
trouble-
shooting
USE Guide & maintenance
