BeLuce Canada Inc., 3900 14th Avenue, Unit 1, Markham, ON L3R 4R3 P: (905) 948-9500 F: (905) 948-8673
INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Disconnect power before performing work on electrical equipment.
3. Do not use outdoors.
4. Use caution when servicing batteries.
5. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to
tampering.
6. The use of accessory equipment not recommended by BeLuce Canada Inc., may cause an unsafe condition, and
will void the unit’s warranty.
7. Do not use this equipment for other than its intended purpose.
8. Servicing of this equipment should be performed by qualified service personnel.
9. SAVE THESE INSTRUCTIONS!
INSTALLATION
WALL MOUNT - SINGLE FACE:
1. Extend unswitched 24 hour AC supply of rated voltage to junction box or appropriate wiring (supplied by others). Leave at least eight (8)
inches of slack wire. The circuit should not be energized at this time.
2. Install (2) plugs into the frame to close canopy holes, push to snap into place.
3. Knock out the appropriate mounting pattern and/or wire pass-thru hole on the back plate to fit the junction box or wiring connector being
used (supplied by others).
4. Bring the wires through the back of the sign and mount the sign securely in place. Screw directly to the junction box if possible.
5. Connect AC supply per diagram provided (Figure 5).
Insulate unused wire!
CAUTION! - Failure to insulate unused wire may result in a shock hazard or unsafe condition as well
as equipment failure.
6. Route wires and secure them in place.
7. Position the pictogram between the posts on the inside of the faceplate and secure with 6 push nuts. (Figure 3)
8. Install faceplate and snap into frame.
9. Turn on the AC voltage supply.
CEILING/END MOUNT - SINGLE OR DOUBLE FACE:
1. Extend unswitched 24 hour AC supply of rated voltage to junction box or appropriate wiring (supplied by others). Leave at least eight (8)
inches of slack wire. The circuit should not be energized at this time.
2. Remove back plate from frame (unsnap). For double face only.
3. Feed wires through frame and through canopy (Figure 1).
3. Install canopy into frame, insert and slide sideways to engage (Figure 2).
4. Install plug into frame to close the remaining canopy hole. Push to snap into place.
5. Connect AC supply per diagram provided (Figure 5).
Insulate unused wire!
CAUTION! - Failure to insulate unused wire may result in a shock hazard or unsafe condition as well
as equipment failure.
6. Route wires and secure them in place.
7. Secure canopy to junction box.
8. Position the pictogram between the posts on the inside of the faceplate and secure with 6 push nuts. (Figure 3)
9. Install faceplate, snap into frame.
10. Turn on the AC voltage supply.
VERDE SD (VE-SD)
926000537
