BeLuce Canada Inc., 3900 14th Avenue, Unit 1, Markham, ON L3R 4R3 P: (905) 948-9500 F: (905) 948-8673
WALL MOUNT INSTALLATION:
1. Remove torx screws (5) to release clear lens (7). There are 4 O-rings (4)
inserted to the clear cover screw holes. Release the open face frame (6) from
the clear lens (7). Peel off backing paper from the tape on the back of the open
face frame (6) and carefully position and stick the desired pictogram to the
open face frame.
2. Remove the backplate (3) knockouts using applicable knockout holes. Install the
liquid tight bushing into the large centre knockout with the lock nut (10). Feed
the lead wires through the bushing and tighten to complete the liquid tight seal
then secure the back plate and housing to the wall. Connect wire per wiring
diagram provided.
Caution! Failure to insulate unused wire may result in a
shock hazard or unsafe condition as well as equipment failure.
3. Replace open face frame, clear lens and torx screws.
4. Apply power.
Parts List
1. Die-cast aluminum frame
2. Frame gasket
3. Die-cast backplate
4. O-ring
5. Torx tamper proof screws
6. Open face frame
7. Clear Lens
8. Bushing
9. Octagon Box
10. Mounting Gasket
11. Pictogram
Figure 1
5
4
7
6
2
1
3
10
8
9
11
926000543
