Display Module
Orange Shrink
1
Determine the best location for the Display
Module. If installed by a professional, the customer
should be consulted. An optimal location is clearly
visible from the driver’s position and does not take a
driver’s eyes off the road for more than a moment.
2
Clean the mounting surface thoroughly.
3
Mount the Display using the pre-applied
adhesive.
4
Route the cable to the Interface and plug into the
connector labeled “Display Module.”
5
Secure and conceal the cable under trim panels.
Display Bezel Mounting
(Continued)
7
Ensure there are no hidden cables, brackets, or
other components behind the location, and that
there is adequate clearance behind the panel. The
Display will protrude into the dash or console by
1/2" to 3/4".
8
Very carefully cut the hole in the mounting
surface.
9
Feed the connector end of the cable through the
opening and route to the Interface.
10
Remove the masking tape protecting the trim
panel.
11
Clean the mounting surface thoroughly.
12
Apply the double-sided adhesive tape to the
display bezel.
13
Mount the Display Module using the bezel
adhesive.
14
Plug the connector into the Interface connector
labeled “Display Module.”
15
Secure and conceal the cable under trim panels.
Control Module
Blue Shrink
1
Determine the best location for the Control
Module. If installed by a professional, the customer
should be consulted. An optimal location is easily
visible and accessible from the driver’s position, and
does not interfere with normal driving. Avoid
locations that require reaching through or around
the steering wheel.
2
Clean the mounting surface thoroughly.
3
Mount the Control using the pre-applied
adhesive.
4
Route the cable to the Interface and plug into the
connector labeled “Control Module.”
5
Secure and conceal the cable under trim panels.
F
G
Display Bezel Mounting
1
The supplied display bezel can be used to mount
the Display permanently in the dash or console.
2
Determine the best location for the Display
Module. If installed by a professional, the customer
should be consulted. A flat, plastic surface with no
obstructions behind it is best for this type of
mounting.
3
Remove the Display Module’s lens by inserting a
fingernail at one end to unsnap the lens.
4
Replace the front lens with the display bezel by
snapping it in place. Ensure that the cable protrudes
from the left end when looking at the display bezel
with the text oriented properly. A small key in the
plastic helps proper assembly.
5
Cover the mounting surface with masking tape
to prevent accidental scratches.
6
Using the supplied hole template, mark the
location.
