6
7
4.
Ka Narrow Bands
– With Super Wideband Ka turned
OFF, any Ka narrow frequency which is engaged is
confi rmed by rapid fl ashing of appropriate signal
strength LED (see page 10).
Pressing PWR anytime during the power up test sequence will
suspend the normal power up test sequence; your unit will be
ready for operation.
Tutorial Mode
The tutorial mode allows you to become more
familiar with all audible and visual alerts. To engage
this mode, press the AUD and the CTY buttons
simultaneously while the unit is ON. The audio/visual
alerts will be presented slowly in order of Laser, K, X,
Ka and SWS. The tutorial mode will cycle the
audio/visual alerts continuously. Press the PWR button
to exit. Two “beeps” confi rm exiting from the tutorial
mode. Your unit is now ON and ready for operation.
Set and Forget Memory
Any time 975e Remote is turned OFF all feature
settings you have selected are retained in the unit’s
memory. Set and Forget Memory eliminates the need
to reset your preferred feature settings each time
your unit is turned OFF and then back ON.
Low Voltage Warning
975e Remote continually checks voltage to ensure
proper performance. The unit’s operating range is
10.0 to 16.0 volts. If voltage falls below 10.0, the
highway (H) or city (C) indicator will fl ash, coupled
with a series of steady audible “beeps.”
Loss of Antenna Connection
In the event the control panel and Radar antenna are
not properly connected, the X/K/Ka band indicators
will
fl ash, coupled with steady audible “beeps.”
Audio/Visual Alert for Instant-On/Pulsed Radar
This type of signal appears suddenly when a Radar
unit is “triggered.” The instant-on or pulsed alert
consists of an intense, three-second, X, K or Super
Wideband Ka audio “burst,” coupled with the fl ashing
of the four-LED display.
DRK
(Bright/Dim/Dark) Button
The DRK button allows selection of a dim or dark
setting for all LEDS. To engage dim mode, press the
DRK button once. A single “beep” confi rms your
selection. To completely cancel the illumination of all
LEDS, press DRK a second time. You’ll notice the city/
highway LED remains dim to confi rm your unit is
receiving power. To return to a full bright setting,
press the DRK button a third time; two “beeps”
confi rm this selection. Use of the DIM button does
not affect audio alerts.
Important—if you press the DRK button and do not receive
audible confi rmation, the audio level has been set too low.
AUD
(Audio Mute/Volume Control) Button
Manual Muting of Audio Alerts (Radar and SWS)
Whether Auto-Mute is selected ON or OFF in
Selectable Features, the audio alerts can be
completely muted by pressing the AUD button during
an alert. No audible alert will be heard for
approximately 12 seconds. If the signal is still present
after 12 seconds, the unit will remain in manual mute
mode.
Volume Control
Press and hold AUD button to engage the volume
control. Release the AUD button when you have
reached your desired audio setting. To reverse
direction of the volume, release and press AUD a
second
time.
Note—because Laser alerts are not lengthy or sustained,
muting is not required (see page 17).
23499_BEL_975eOM.indd 7-8
23499_BEL_975eOM.indd 7-8
5/14/07 9:38:38 AM
5/14/07 9:38:38 AM
