Doc 0256680 rev L
Page 16 of 22
Not subject to issue control when printed
Reassemble
Mount batt door and push in the pin to fix it to the module
. Make sure the pin is correct in place. Slide the
module into the bot HSG and check it is aligned with holes for pins
Mount top HSG sliding it towards the bat door end to avoid damaging the HSG taps. Make sure it is correct in place Mount the two pins. Make sure the
pins are correct in place. Mount the rec. Press down the conn lock to fix the rec
If the conn lock is damaged, mount a new one into the TOP HSG: Pick up a new conn lock. Make sure the
tap on the conn lock is mounted in the correct direction into the corresponding hole in the TOP HSG. Insert
conn lock and press until it is correct in place