Bellwave BSM-856, User Manual

Page: 13 / 31

-13-
User’s Manual (preliminary)
[&D1]
Enter online command state
following ON-to-OFF transition
of circuit 108/2. See service
specific AT command processing
for service state transitions.
Async: R,L
Packet: R
Fully
Implemented
&D2
Enter command state following
On to Off transition of circuit
108/2. See service specific AT
command processing for service
state processing requirements.
Async: R,L
Packet: R
Fully
Implemented
T
Select tone dialing. Async: R,M
Packet: N/A
Normal Dialing
P
Select pulse dialing. Async: R,M
Packet: N/A
Normal Dialing
&Fn
Set to factory-defined
configuration “n.” Effect is
implementation dependent.
Async: R,M
Packet: O
Fully
Implemented
Note. For Async data or fax settings, the dial tone detection settings do not apply.
Legend: R=Required, O=Optional, M=Remote AT Command, L=Local AT Command.
3.3.4
Basic S Registers
Table 2.1.4-1 specifies the basic S Registers to be supported for the CDMA data
services. Exceptions to EIA/TIA-602 are indicated in Table 2.1.4-1 by square brackets.
Default settings are shown in bold.
Reg
Value Description IS-707 req’t Implement
status
S0
0
[1 to
255]
Disable automatic answering.
[Enable automatic answering
after
(Value - 1) 6 seconds.]
Async:R,L
Packet: N/A
Fully
Implemented