Bellucci Slim Latte Automatic Coffee Machine
Instruction Manual
Page 20 of 21
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance does not work. The appliance is not
connected to the mains.
- Plug in and press the switch.
- Check the cable and the Plug
No or delayed response in
several trials of pressing on
function key on the panel
- Appliance is under an
electromagnetic interference
- Dirt over the panel
- Unplug the appliance. Restart after few
minutes
- Clean the panel with the cloth provided
The coffee is not hot enough. - The cups have not been
preheated.
- The brewing unit is too cold.
- Rinse the appliance at least 3 times before
making the coffee.
The coffee cannot come out
from spout.
Empty system function maybe
used before.
Press the hot water button until water can come
out from spout.
The first cup of coffee is
poor quality.
The first run of grinder does
not pour sufficient quantity
coffee power into the brewing
unit.
Throw the coffee away. The other coffees will
always be of good quality.
Coffee has no cream.
- Coffee bean is not fresh.
Change or using appropriate brand of coffee
bean.
The touch buttons are not
sensitive
Not pressing the touch button
from the front direction of the
appliance
Press the lower bottom part of the icon of the
touch button from the front direction of the
appliance.
The appliance takes too long
time to warm up.
Excessive scale has built up. Descale the appliance.
The water tank is removed /
the water level is very low in
the water tank but
have no alert.
The area near the water tank
connector is wet.
Wipe the water around the water tank connector
Internal drip tray is filled
with a lot of water.
Coffee powder too fine which
block the water to come out.
Adjust the coffee fineness to bigger dot during
grinder operation.
Coffee is delivered too slowly
or a drop at a time.
Coffee powder too fine which
block the water to come out.
Adjust the coffee fineness to bigger dot during
grinder operation.
Lack of bean indicator
flashes but there is still a lot
of coffee bean inside the
container.
Internal coffee powder outlet
is blocked.
To follow the steps of section E (V. Cleaning
coffee powder outlet).
No milk foam out from the
machine
The automatic milk frother is
dirty or not assembled or
installed correctly
Clean the automatic milk frother and make sure
it is correctly assembled or installed.
No milk foam out from the
machine
The hole of the Milk tube
connector is blocked by milk
residues
Refer to section “D
aily Cleaning of the
appliance”, follow
“cleaning the milk container
and connection milk tube”,
Clean the connector
and make sure all the hole on the connector is
clean, use needle or bristle of brush to clean the
hole.
The hole of the Milk tube
The milk tube connector has
Soaking the connection milk tube into warm
