Indicators and Signals
It is generally the transmitters in the Bellman Visit 868 System that determine how the receivers will indicate an alarm. See
the description in the relevant transmitter user manual for further information. The Bellman Visit 868 Portable Receiver has a
function which allows you to easily check which alarm was the last one detected. If you press the Test Button (12) once, the
last alarm will be repeated.
System indicators
The LED (2) blinks once when the Bellman Visit 868 Portable Receiver is activated by a transmitter sending a radio signal to
the Receiver.
The LEDs (4 - 7) that indicate which transmitter has activated the Bellman Visit 868 Portable Receiver normally have the
following meanings:
• Orange LED (4) indicates a baby cry transmitter.
• Green LED (5) indicates a door transmitter.
• Yellow LED (6) indicates a telephone transmitter.
• Red LED (7) indicates a fire alarm
If the green (5) and yellow (6) LEDs blink alternately, this indicates that the Bellman Visit 868 Portable Receiver is in radio
key selection mode. The Bellman Visit 868 Portable Receiver will then wait for a radio signal from a transmitter in the
Bellman Visit 868 System which will adjust the receiver to the same radio key as the transmitter is tuned to.
Sound
The Bellman Visit 868 Portable Receiver sounds an alarm. The sound volume can be adjusted between 0 and 93 dBA
maximum at 1 metre by using the volume control (1). The main frequency range is 500 – 1000 Hz. Refer to the user manual
for the relevant Bellman Visit 868 transmitter for more information about the types of sounds that can be emitted.
Light
When the Bellman Visit 868 Portable Receiver is activated, the LEDs (3) blink with a bright light.
Vibration
The Bellman Visit 868 Portable Receiver can power a BE1270 Bellman Bed-shaker (accessory) connected to the socket (8).
The bed shaker is placed under the pillow to wake the user up when the Bellman Visit 868 Portable Receiver is activated.
Refer to the user manual for the relevant Bellman Visit transmitter for more information about vibration patterns.
Power supply
When the LED (2) lights up green during activation, the unit is working correctly.
When the LED (2) lights up yellow during activation, the unit is working correctly, but the batteries are flat and must be
changed. Only use LR14 alkaline type batteries.
When the LED (2) is constantly green, the Bellman Visit 868 Portable Receiver is powered by an external power supply
(accessory) via the power supply unit connection socket (9).
Troubleshooting in brief
Problem
Solution
Nothing happens.
• Change the batteries. Only use LR14 alkaline type batteries.
The receiver is not emitting
any sound signals.
• Turn up the volume using the volume control (1).
The receiver emits a sound but
no light signal.
• Check that on/off light signal switch (11) is set to the ON position.
The LED (2) lights up yellow
when the Receiver is activated.
• Change the batteries. Only use LR14 alkaline type batteries.
The receiver is not activated,
but works when the test button
is used.
• Check the battery in the transmitters.
• Check that the receiver is not placed too far away from the
transmitters by moving it closer to the transmitters.
• Check that the receiver is set to the correct radio key. For further
information see Function/Radio key.
The receiver signals when no
transmitter is activated.
• Change the Radio Key on all units in the system. For further
information see Function/Radio key.
Page 2 of 3
Bellman Visit 868 Portable Receiver, BE1450
19/04/2010
http://www.bellman.se/web/bellmanuals/showm1450.php?lang=gb&tbn=m1450
