For further information about the product visit
bellman.com
.
Regulatory symbols
With this symbol, Bellman & Symfon confirms that the product meets the Medical Device
Regulation EU 2017/745.
This symbol indicates the manufacturer’s serial number so that a specific medical device
can be identified. It’s available on the product and gift box.
This symbol indicates the manufacturer’s catalogue number so that the medical device
can be identified. It’s available on the product and gift box.
This symbol indicates the medical device manufacturer, as defined in EU Directives
90/385/EEC, 93/42/EEC and 98/79/EC.
This symbol indicates that the user should consult the instruction
guide and this leaflet.
This symbol indicates that it is important for the user to pay attention to the relevant
warning notices in the user guides.
This symbol indicates important information for handling and product safety.
Temperature during transport and storage: –10° to 50° C, 14° to 122° F
Temperature during operation: 0° to 35° C, 32° to 95° F
Humidity during transportation and storage: <90%, non-condensing
Humidity during operation: 15% to 90%, non-condensing
Atmospheric pressure during operation, transportation and storage:
700 hpa to 1060 hpa
Operating
conditions
This device is designed such that it functions without problems or restrictions if used as
intended, unless otherwise noted in the user guide or this leaflet.
With this CE symbol, Bellman & Symfon confirms that the product meets EU standards
for health, safety, and environmental protection as well as the Radio Equipment Directive
2014/53/EU.
This symbol indicates that the product shall not be treated as household waste. Please
hand over your old or unused product to the applicable collection point for the recycling
of electrical and electronic equipment or bring your old product to your hearing care
professional for appropriate disposal. By ensuring this product is disposed of correctly, you
will help prevent potential negative effects on the environment and human health.
Troubleshooting
Most problems with the wrist receiver can be solved quickly by following the advice below.
If
Try this
The receiver seems to
be turned off
The battery is depleted. Charge or replace it with a VARTA
V40H NiMH battery.
The battery LED blinks
in yellow
The battery level is low. Charge or replace it with a VARTA
V40H NiMH battery.
The receiver is not
charging
Check that the receiver is placed correctly in the charger
and that the power supply is connected. The mains LED and
charging LED should be lit.
Charge or replace the backup batteries with four 1.2 V NiMH
rechargeable batteries.
The receiver does
not respond when a
transmitter is activated
Check the transmitter batteries and connections.
Move the receiver closer to the transmitter to make sure it’s
within radio range.
Check that the receiver is set to the same radio key as the
other units in the Visit system, see
Changing the radio key
.
The receiver is activated
for no apparent reason
There is probably another Visit system installed nearby that
triggers your system. Change the radio key on all units, see
Changing the radio key
.
The bed shaker does
not vibrate
Check that the bed shaker is connected and that the receiver
is placed in the charger.