General warnings
This section contains important information about safety, handling and operating
conditions. Keep this booklet for future use. If you are just installing the device, this
booklet must be given to the householder.
Hazard warnings
Failure to follow these safety instructions could result in fire, electric shock, or other
injury or damage to the device or other property.
The wrist receiver and charger can only be used with rechargeable NiMH batteries!
Non-rechargeable batteries will start to leak if recharged! The acid in the batteries will
damage the electronics in the wrist receiver and the charger. The resulting damage will
not be covered by any guarantee.
Only use Varta V40H batteries for the wrist receiver
and Lexel 600AAA batteries for the charger.
Be aware that alarms and notifications can be missed if batteries run out.
Keep this device out of reach of children under 3 years.
Batteries are toxic. Do not swallow them! Keep out of reach of children and pets. If they
are swallowed, consult your physician immediately!
Do not use or store this device near any heat sources such as naked flames, radiators,
ovens or other devices that produce heat.
Use only power adapters and battery types that are specified in this leaflet.
Protect cables from any potential source of damage.
This device is designed for indoor use only. Do not expose the device to moisture.
Protect the device from shocks during storage and transport.
Do not make any changes or modifications to this device. Use only original Bellman &
Symfon accessories to avoid any electrical shock.
Information on product safety
Failure to follow these instructions could result in damage to the device and void the
warranty.
Do not expose batteries to fire or to direct sunlight.
Rechargeable batteries should be charged fully before using the device for the first
time. Only charge batteries in a temperature between 0°– 35°C, 32°– 95° F.
If a serious incident occurs in relation to this device, contact the manufacturer and
relevant authority.
Do not drop your device. Dropping onto a hard surface can damage it.
The device may only be repaired by an authorized service center.
If you encounter other problems with your device, contact the point of purchase, your
Compatible Visit transmitters
BE1411 Visit door transmitter
BE1420 Visit pushbutton transmitter
BE1431 Visit telephone transmitter
BE1432 Visit mobile phone transmitter
BE1481 Visit smoke alarm transmitter
BE1551 Visit smoke alarm transmitter
BE1555 Visit CO alarm transmitter
BE1491 Visit baby monitor
Available accessories
BE1270 Bed shaker
For detailed product information, see the corresponding user manual.
Operating conditions
Operate the device in a dry environment within the temperature and humidity limits
stated in this leaflet. If the device gets wet or is exposed to moisture, it should no longer
be regarded as reliable and should therefore be replaced.
Cleaning
Disconnect all cables before you clean your device. Use a soft, lint-free cloth. Avoid
getting moisture in openings. Do not use household cleaners, aerosol sprays, solvents,
alcohol, ammonia or abrasives. This device does not require sterilization.
Service and support
If the device appears to be damaged or doesn’t function properly, follow the instructions
local Bellman & Symfon office or the manufacturer. Visit
bellman.com
for contact info.
Do not use the device in areas where electronic equipment is prohibited.
Without permission granted by the NCC, no company, enterprise or user is allowed to
change the frequency, enhance the transmitting power or alter the original character-
istics or performance on an approved low power radio frequency device.
This device should not be used on aircrafts unless specifically permitted by flight personnel.
The wrist receiver will not vibrate when it’s in the charger. A bed shaker must be con-
nected to the charger to provide a vibratory alert. Other indicators will act as normal.
Apart from a bed shaker, it is also possible to connect other products such as some
Bellman & Symfon alarm clock models to the vibrator output.
Configuration options
The BE1560 wrist receiver can be configured with the following Visit transmitters and
original accessories:
