72
73
Signal
switch
Exterior external
trigger
Pushbutton
Green 1
Orange 1
Green 2
Orange 2
Green 3
Orange 3
Green 4
Orange 4
Green 1
Yellow 1
Green 4
Yellow 4
VMA
VMA
Fire alarm
Fire alarm
Testing
It is easy to test the Bellman Visit 868 Repeater. If the Repeater does not work as described below,
you can check further under Troubleshooting/Troubleshooting guide.
How to test
A transmitter in the Bellman Visit 868 System which is set to the same radio key as the Repeater is
required to test the radio reception on the BE1510 Bellman Visit 868 Repeater.
• Press the transmitter test button.
• The Bellman Visit 868 Repeater will indicate by blinking with the LED (1).
To test the Transmitter:
• Make sure that the Repeater is correctly connected.
• Activate the Repeater via the Test Button (2) or via the Exterior External Trigger (3).
• The Repeater should now light up LED (1) to show that it has been activated and that it is
transmitting a signal to the receivers in the Bellman Visit 868 System.
• The receivers in the system will indicate an alarm according to the way that the Repeater has been
set up using the Signal Switches (4).
