6
Unpacking the appliance
When unpacking the appliance please check
that the following items are contained within the
packaging:
1 Ceramic hob
1 Installation and instruction manual
4 Fixing screws & clips
4 Clamps
1 Sealing strip
1 Cleaning kit
Installing the appliance
Hob and Aperture Dimensions
MODEL
A
B
C
D
E
CCH77601
770
510
750
490
53
• Cut a hole in the worktop that corresponds
with the drawings shown above.
•
IMPORTANT
: You must have a gap of at
least 25 mm between the underneath of the
appliance and any surface that is below it.
• Carefully turn the hob upside down and place
it on a cushioned mat.
• Apply the sealing strip provided around the
edge of the appliance.
• The protective covering must be removed from
both sides.
• Do not leave a gap in the sealing agent or
overlap the thickness.
•
IMPORTANT
: Do not use a silicon sealant to
seal the appliance against the aperture. This
will make it difficult to remove the hob from the
aperture in future, particularly if it needs to be
serviced.
Installation Step
Firstly, insert the clip into the slot from side as fig
a,b &c.
Secondly, place the clamp (B) over the holes that
match the size of the screws. There are one set
of screw holes in each corner of the hob. Slightly
tighten a screw (C) through the clamp (B) to which
the clamp is attached to the hob by the clips so
that you can still adjust the position of it as fig.D &
E finish other clamp & clip as same method.
Then, Carefully turn the hob back over and then
gently lower it into the aperture hole that you
have cut out.
Finally, on the underneath of the hob, adjust the
clamps into a position that is suitable for your
worktop. Then fully tighten the screws (C) to
secure the hob into position as fig e.
Fig. A
Sealing strip
4x clamp
4x clip &
fixing screw
1 Cleaning kit
