6
•
Place the clamp (B) over the holes that match
the size of the screws. There are one set of
screw holes in each corner of the cooktop.
Slightly tighten a screw (C) through the
clamp (B) so that the clamp is attached to the
cooktop, but so that you can still adjust the
position of it.
•
Carefully turn the cooktop back over and then
gently lower it into the aperture hole that you
have cut out.
•
On the underneath of the cooktop, adjust the
clamps into a position that is suitable for your
worktop. Then fully tighten the screws (C) to
secure the cooktop into position.
Installing the appliance
•
Cut a hole in the worktop that corresponds
with the drawings shown above.
•
IMPORTANT
: You must have a gap of at
least 25 mm between the underneath of the
appliance and any surface that is below it.
•
Carefully turn the cooktop upside down and
place it on a cushioned mat.
•
Apply the sealing strip provided around the
edge of the appliance.
•
The protective covering must be removed from
both sides.
•
Do not leave a gap in the sealing agent or
overlap the thickness.
•
IMPORTANT
: Do not use a silicon sealant to
seal the appliance against the aperture. This
will make it difficult to remove the hob from the
aperture in future, particularly if it needs to be
serviced.
GSM Sales Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: 1300 373 199 Aust OR 0508123108 NZ www.belliniappliances.com.au
Model: BST601X-F Fineline: 267897 NZ Only 60cm Electric Cooktop Included in Builders Pack BPT150EE Fineline: 5103598
