Installation
WARNING!
Please follow the points below when installing the appliance
Use an Authorized Person
As stated in the local municipal building codes
and other relevant statutory regulations:
Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
Refer to data plate for rating information. The
data plate is positioned at the side of cavity.
A functional switch should be provided near the
appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1.
Wiring should be protected against mechanical
failure. Refer to AS/NZS 3000 clause 1.5.
A means of disconnection with a contact
separation of at least 3mm must be supplied in
the fixed wiring.
Disconnect the power plug of the appliance from
the power point when conducting maintenance
or repairs to the unit
This Appliance Must Be Properly Earthed
Do not lift the appliance by the door handles.
Prepare the cupboard opening to match your
appliance measurements. (See diagrams).
Slide appliance in to cabinet cavity, ensuring
supply cable is not obstructed (kinked, jammed
or
twisted).
To prevent tipping or dislodging of the appliance,
secure appliance to the cabinet with 2 screws
(provided), through the dedicated holes in the
appliance frame.
Where the appliance is built into a cabinet, the
cabinet material must be capable of withstanding
120°C. Installation into low temperature tolerant
cabinetry (E.g. vinyl coated) may result in
deterioration of the low temperature coating by
discoloring or bubbling.
The cabinet panels to the oven must be heat
resistant. With veneered wood units, glues must
be resistant to a temperature of 1
2
0
C.
available from the vinyl-wrap supplier.
GSM cannot accept responsibility for damage
caused by installation into low temperature
tolerant cabinets.
After installation, test and ensure the appliance
operates correctly before handing it over to the
customer.
CAUTION!
Where the appliance is connected via power supply
cable to a power point, the installed power point must
remain accessible after appliance installation
A dedicated power circuit is recommended for the unit
but not required. Additional electrical appliances on
the same circuit may exceed the current (amperage)
rating for that circuit. If after the installation of your
unit the circuit breaker trips or the fuse fails on a
repeated basis, then a dedicated circuit will likely be
required.
WARNING!
To avoid any potential hazard, you must
follow our instructions when you install
your appliance. Failure to install the
appliance correctly could invalidate any
warranty or liability claims and lead to
prosecution.
Install the shelf
1. Pay attention to high temperature, you may need
to wear gloves if it is hot inside.
2. Always slide shelves into the layer with stopper.
If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit
6
