Installation
6
WARNING!
Please follow the points below when installing the appliance
Use an authorized person
As stated in the local municipal building codes
and other relevant statutory regulations:
Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
Refer to data plate for rating information. The
data plate is positioned behind the bottom of the
oven door. The circuit diagram is positioned on
the top panel of the appliance.
A functional switch should be provided near the
appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1
Wiring should be protected against mechanical
failure. Refer to AS/NZS 3000 clause 1.5
A means of disconnection with a contact
separation of at least 3mm must be supplied in
the fixed wiring.
Disconnect the power plug of the appliance from
the power point when conducting maintenance
or repairs to the unit
This appliance must be properly earthed.
Do not lift the appliance by the door handles.
Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
Slide appliance in to cabinet cavity , ensuring
supply cable is not obstructed ( Kinked , Jammed
or twisted )
To prevent tipping or dislodging of the appliance ,
secure appliance to the cabinet with 4 screws
(provided ) , through the dedicated holes in the
appliance frame
Where the appliance is built into a cabinet, the
cabinet material must be capable of withstanding
70°C. Installation into low temperature tolerant
cabinetry (e.g. Vinyl coated) may result in
deterioration of the low temperature coating by
discoloring or bubbling.
The cabinet panels to the cooker must be heat
resistant. In the case of veneered wood units,
glues must be resistant to a temperature of 100
℃
If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit
available from the vinyl-wrap supplier.
GSM cannot accept responsibility for damage
caused by installation into low temperature
tolerant cabinets.
After installation, test and ensure that the
appliance operates correctly before handing it
over to the customer.
CAUTION!
Where appliance is connected via power supply
cable to a power point, the installed power point
must remain accessible after appliance installation
A dedicated power circuit is recommended for the
unit but not required. Additional electrical
appliances on the same circuit may exceed the
current (amperage) rating for that circuit. If after the
installation of your unit the circuit breaker trips or
the fuse fails on a repeated basis, then a dedicated
circuit will likely be required.
WARNING!
To avoid any potential hazard, you must
follow our instructions when you install
your appliance. Failure to install the
appliance correctly could invalidate any
warranty or liability claims and lead to
prosecution.
Summary of Contents for BO610CX
Page 20: ...19 NOTES...
