Bellfires Free Bell, Installation Instructions And Instructions For Use, Page: 16 / 56

16
Bell
fi res
English
Instructions for use and installation instructions
Important: • If you turn on the main burner by pressing the (large fl ame)
button, it must ignite within 10 seconds.
If this does not happen, immediately close the gas tap and
warn the fi tter.
• If the main burner ignites with a pop; immediately close the gas
tap and warn the fi tter.
Switching off the appliance
• Press the (small fl ame) button to lower the fl ames or to switch off the main burner.
• Then press the « -OFF button to switch off the appliance, including the pilot light.
• Press the “ O I ” switch (on the gas control block) to the “ O ” position. This conserves
battery life.
• If the appliance is not to be used for some time, please close the gas supply valve in
the gas pipe.
Important: If the pilot fl ame goes out for any reason,
wait for 5 minutes before attempting to
re-light it.
Faults
• If the signals from the hand-held transmitter do not seem to be reaching the receiver,
the cause may be:
* Spent batteries: replace the batteries.
* An electronic problem: press the “
RESET ” button on the receiver.
• If the appliance regularly switches itself off, please contact your installer.
Replacing the batteries
• The hand-held transmitter/receiver batteries have a service life of approx. one year.
We recommend you use alkaline batteries.
• The batteries must be replaced whenever:
1 Hand-held transmitter: BATT appears in the display screen.
2 Receiver:
3x short audio signal, audible when the motor-knob
operates.
1 Hand-held transmitter:
* Open the cover on the back of the transmitter.
* Carefully remove the 9V battery and disconnect it from the contact.
Do not pull the wires!
* Connect the new battery and replace in the battery compartment. Close the cover.