Bellfires Corner Bell Large 3 L/R CF, Installation Manual

Page: 10 / 80

10 Bell fi res Installation instructions
PRE INSTALLATION INSTRUCTIONS
The appliance can be installed as an insert into an existing open fi re place or as a built-
in appliance in a new fi re place. In order to prevent the fi replace heating up excessively,
it must be properly ventilated by installing vents at the top of the fi replace.
The provided barrier safety screen designed to reduce the risk of burns from the hot
viewing glass shall be installed.
If an existing chimney is to be used, please consult your installer fi rst. If the chimney
was previously used for a wood or coal fi re, then it should be cleaned by an expert.
CONCENTRIC FLUE SYSTEMS
• M&G DuraVent - Direct Vent Pro ..................................... 4” x 6⅝” and 5” x 8”
• SELKIRK - DIRECT-TEMP - Direct Vent Products ......... 4” x 6⅝” and 5” x 8”
• METAL-FAB - Sure-Seal - Direct Vent Products ............ 4” x 6.5” and 5” x 8”
The appliance, in combination with the concentric flue system [4” x 6⅝”] and/or [5” x 8”]
(rigid and/or fl exible) for the brands, M&G DuraVent (Direct Vent Pro), Selkirk (Direct
Temp) or Metal-Fab (Sure-Seal) has been approved in accordance with the ANSI / CSA
standard for direct vented gas appliances and may therefore be used only with these
systems.
The permitted components for these systems are listed in Chapter “Vent Installation”.
The guarantee on the appliance lapses if it is installed, fully or partially, with other
components or a different flue system.
The concentric flue [4” x 6⅝”] and [5” x 8”] systems can be used with either a newly-built
or existing chimney.
N.B. If any part is missing, please contact your dealer.
INCLUDED WITH THE APPLIANCE
Set documentation - Instructions for use
- Installation instructions
Attributes - Barrier
- Ceramic log set
- Propane conversion kit View Bell Medium 3 CF