H3OCTKTB2BSN
Bellagio By Airworks
6
If your heater fails to operate, please follow these procedures prior to contacting Customer Service:
Problem
Probable Cause
Solution
Heater is not plugged into a
120V polarized
outlet/receptacle.
Ensure unit is in OFF position. Plug in unit and attempt to
turn on again.
The heater fell over and the
Tip-Over Switch temporarily
shutting off the unit.
Turn heater off and unplug. Position heater in an upright
position and ensure the unit is on a flat and even surface.
To resume normal operation, simply plug heater back into a
properly polarized outlet.
Thermal Cut-Off has
temporarily turned off the
heater due to high
temperatures.
Turn heater off and unplug. Allow it to cool for 30 minutes.
Once heater has cooled off, check to make sure there are
not objects on or very close to the unit. To resume
operation, plug unit back in once it has cooled off.
Heater will not
power on.
Breaker/Fuse has been
tripped.
Please check your electrical box to confirm the breaker has
not been blown. This may occur if the unit is sharing a
receptacle with another high power consuming appliance.
Ensure unit is in OFF position. Plug in unit and attempt to
turn on again.
Attempt to plug unit into another independent receptacle in
the house.
Room temperature has
been warmed up to
thermostat setting.
To resume heating, adjust thermostat to a higher setting.
Refer to THERMOSTAT section for more information.
Power light is
on, but no heat
is released
from unit.
The timer was set for the
heater to turn off
automatically.
Turn the timer function OFF by pressing the timer button
until lights at the hour numbers are all off. For more
information, see TIMER section.
A drop of oil fell on the
heating coil during the
manufacturing process. It
will quickly evaporate and
should not occur again.
Ensure room in which heater is situated is well ventilated.
The heater is
creating a
burning smell.
Check & ensure there are
no combustible materials 3
ft (0.9m) surrounding the
heater.
Remove the combustible units preventing air intake into the
heater.
Unit over heats,
temporarily
disabling unit.
Objects placed near the
heater preventing proper air
circulation.
Ensure room in which the heater is situated is well ventilated
and there is at least 3 ft (0.9m) of space between the heater
and any objects.
DO NOT RETURN THE UNIT TO THE STORE OF PURCHASE. If the problem
still persists, refer to the warranty. For more information call 1-800-268-7622 for
service.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO COULD VOID
THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
TROUBLESHOOTING
