bell
issimo
2-72 Way Video Entry System
PD-098 Issue 4B
Installation and Operating Manual
Page 19 of 44
Camera Numbering DIP SW3 (1-8)
Camera 1 at this door
Last Camera
4
3
2
1
Number
8
7
6
5
Number
On On On On *1
On On On On *1
On On On Off 2
On On On Off 2
On On Off On 3
agama
On On Off On 3
On On Off Off 4
On On Off Off 4
On Off On On 5
On Off On On 5
On Off On Off 6
On Off On Off 6
On Off Off On 7
On Off Off On 7
On Off Off Off 8
On Off Off Off 8
Off On On On 9
Off On On On 9
Off On On Off 10
Off On On Off 10
Off On Off On 11
Off On Off On 11
Off On Off Off 12
Off On Off Off 12
Off Off On On 13
Off Off On On 13
Off Off On Off 14
Off Off On Off 14
Off Off Off On 15
Off Off Off On 15
Off Off Off Off 16
Off Off Off Off 16
*Default setting
View Activated by User (CCTV mode)
User activation on 2-72 way system is not available.
‘Global View’ at Multiple Entrances
For information on this feature consult Bell System (Telephones) Ltd. technical department
at the number shown on the last page.
BSD8/72 Door Controller Jumper Settings
Camera Terminator
There is a separate jumper for both video Camera inputs. This has three settings, 75R for
terminating coaxial cable, 100R for terminating twisted pair Cat5 cable and None for use
when passing the cable on to another device or controller.
Video Gain Control
The “Video Gain” jumper on door controllers should always be set to “0” unless directed by
‘Bell System Technical Support’. This jumper is only required on some systems with very
long camera to videophone cable runs well in excess of 150m. Inappropriate use of this
jumper with short runs will cause picture problems.
Reassurance tones
DDA reassurance tones are activated by placing a jumper between pins 1 & 2 of the
“Prog” 5 pin header on the BSD8/BSD72 controller PCB (see diagram on page 30), the
jumper is stored between pins 4 & 5. Once activated the speaker in the door panel will
ring with the videophone and buzz when the lock is opened from the videophone.
SW1 SW2 SW3
(ASDFGH
JK)
(ASDFGH
JK)
(123456
78)
OFF ↔ ON
