BF Apartment Station Digital Entry System
PD
–166 Issue 1
Installation and Operating Manual
Page 24 of 48
Odd/Even Addressing Jumper PROG pins 1-2
This jumper alters the addressing of Phone outputs 2, 3 and 4 such that they all become
either odd or even numbers. So if the address of output Phone 1 is 12 say the other
outputs become 14, 16 and 18. If the address were 31 then the other outputs are 33, 35
and 37.
The use of this jumper precludes the use of extended addressing by PROG pins 2-3, if
both are required contact Bell System Technical. The jumper is stored on pins 4-5.
Extended Addressing Jumper PROG pins 2-3
This jumper adds +3200 to the Phone 1 address set using SW6 and SW7. Phone
addresses up to 6410 (Phone 1 output) can be set. Custom versions will show the custom
offset on the build label.
The use of this jumper precludes the use of Odd/Even addressing by PROG pins 1-2, if
both are required contact Bell System Technical. The jumper is stored on pins 4-5.
Custom Alternate Addressing Option
Special versions of the BSC4 can be ordered to allow addressing above 6413. The value
+nn00 is shown on the build label. This jumper adds +nn00 to the phone 1 address set
using SW6 and SW7The jumper is stored on pins 4-5.
For instance by a custom version Build 7+5000 would make the jumper add 5000, the
BSC4 would then be able to address from 1 to 3210 and 5001 to 8210 (Phone 1 output).
The use of this jumper precludes the use of Odd/Even addressing by PROG pins 1-2, if
both are required contact Bell System Technical. The jumper is stored on pins 4-5.
