Bell Phones 31331, User Manual

Page: 12 / 30

3
3. Place the battery compartment
cover by sliding it up towards the
handset.
NOTE: Use the type and size of Ni-
MH battery pack, 2.4V AAA battery
pack. It is recommended that the Ni-
MH battery pack should be fully
charged minimum 16 hours prior to
initial use.
POWER CONNECTION
CAUTION:
For Base Unit:
You must use a Class II, 120 Volt AC / 6
Volt DC adaptor that delivers at least
200 mA. The center tip must be positive
and the plug must correctly fit the unit’s
6.0V DC jack.
BASE UNIT BACK:
INITIAL SETUP
Please follow these steps before using
this DECT 6.0 phone for the first time.
•
Ensure that the handset battery
pack is installed and charged fully
for at least 16 hours.
•
Ensure that all connections (line
cord and adaptor cord) are
properly inserted into the rear of
the base unit.
Setting to TONE/PULSE Mode
•
If your home is equipped with
tone-dialing service set the
TONE/PULSE setting to TONE
(default setting of your phone is
TONE).
•
If you have a Pulse (Rotary)
dialing service, set the
TONE/PULSE change the
setting to Pulse following the
procedure on setting the
TONE/PULSE.
If you are not sure which system you
have, set the TONE/PULSE Set the
phone to TONE. Press the [TALK
BUTTON] the handset to get a dial
tone, and press any button on the
TELEPHONE KEYPAD except the
zero. If the dial tone continues, it
means that you do not have TONE
dialing service. Press the [OFF
BUTTON] on the handset to hang
up. Set the TONE/PULSE setting to
the PULSE and then try again.
LCD INFORMATION
The following LCD display icon will
be displayed when each of its
function is activated.
Icon Function Indication
Name or Number
Display