Figure 6
Pumps can be installed in the piping with floor mounted
saddles adequate to carry the loads from the pump and
piping. See
Figure 6:
on page 13
Figure 7
Optional B&G Flange Supports can be used when rigid
pump support to the floor or isolation base is required.
The supports are installed on the back side of the pump
flanges and have tapped holes to accept the flange
bolting and have mounting holes in their bases for
anchor bolts. Pipe supports (not shown) are required such
that the pump flanges are not supporting the piping. See
Figure 7:
on page 13
Figure 8
Alternately with the optional B&G Flange Supports,
isolation pads can be used between the support and the
floor. See
Figure 8:
on page 13
Figure 9
For seismic region installation, use seismically-rated
isolation pads between the flange supports and the
concrete foundation. See
Figure 9:
on page 13
Figure 10
e-80SC pumps have a four bolt circle on the bottom of the
volute to accept an ANSI/ASME flange that can be used
with a connected pipe as a temporary pump support
while the permanent pump piping or pump supports are
being fitted to the pump. This support can only be used
to handle the pump weight as it is not suitable to resist
loads in other directions. See
Figure 10:
on page 13
For installations in grooved piping systems when the pump is supported by the piping,
flange locking type grooved piping connections are required to prevent the pump from
rotating in the piping.
4 Installation
Series e-80SC INSTRUCTION MANUAL
13
Summary of Contents for e-80SC Series
Page 1: ...INSTRUCTION MANUAL P2002880 Rev C Series e 80SC ...
Page 2: ......
