Setup Instructions | 03
Operating Instructions | 0
Wall-Mounting the TuneStage 2 Receiver (Optional)
1.
Make sure the antenna is pointed upward.
2.
You can hang the Receiver on a wall using two screws (not included).
3.
The cables should run through the channel on the bottom of the Receiver, so they are held
securely to the wall.
Setup Instructions
STEP 2: TuneStage 2 Transmitter Setup
1.
For best results, the Transmitter should be close to the Receiver when first making the
wireless connection.
2.
Power on your iPod, and then insert the TuneStage Transmitter into the bottom of the
iPod. Wait approximately two seconds and press “PLAY” on the iPod.
3.
The Transmitter will power on automatically, and the blue LED will begin to blink rapidly
while it searches for the Receiver to which to pair. The Receiver LED will also blink rapidly
during this search mode.
4.
The Transmitter and Receiver will pair with each other within 60 seconds. When the devices
are paired and ready, the LED on the Receiver will remain on and the LED on the Transmitter
will blink slowly.
NOTE:
The next time you start up the TuneStage , it will pair much faster
as the Receiver remembers the last device with which it paired. This will usually happen in
less than 0 seconds.
5.
You can now play any song on your iPod through your stereo. For the best audio quality,
adjust the volume level on your stereo to less than 50-percent full, and use just the iPod to
change the volume up or down.
Operating Instructions
80mm
iPod with video 30GB
