18
Connecting and Configuring the Router
Connecting and Configuring the Router
3.3
The Wizard will now transfer all
of the configuration information
to the Router. This will take
approximately one minute. During
this time, do not turn off the
Router or computer. The Router
will restart itself at the end of
this step.
3.4
The Wizard will now check for
an Internet connection. This can
take a few minutes. The Wizard
may not detect a connection right
away. If not, it will retry 10 times.
The “Connected” light on the
front panel of the Router will flash
during this time. Please be patient
through this process.
Note:
If the Easy Install Wizard repeatedly displays an error message
that says it cannot make an Internet connection, you may have to
power cycle your modem in order to establish an Internet connection.
This step will allow the modem to reconfigure itself properly to work
with the router. Please follow the instructions below:
Sequence:
1.
Unplug the power from the modem (supplied by your ISP).
2.
Unplug the power from your Belkin Router.
3.
Wait for five minutes.
4.
Reconnect power to the modem.
5.
Wait for the modem to power up (about one minute, please refer
to the modem’s documentation).
6.
Reconnect power to the Router.
7.
Check your Internet connection.
