Belinea 2025 S1W - Operating Instructions -
ENGLISH
INTRODUCTION
This manual will familiarize you with the installation and
use of your Belinea monitor. Please take the time to
look through these instructions even if you are familiar
with monitors.
We have taken all possible care to ensure that this
manual contains correct, accurate information. However,
the manufacturer cannot assume liability for any possible
errors. In addition, the manufacturer cannot guarantee
that the hardware will meet the purpose you require. We
would appreciate reports of any errors, suggestions or
criticism.
© Copyright 2006
MAXDATA Systeme GmbH
45768 Marl, Germany
www.maxdata.com
Editing, DTP and translation by think global GmbH,
www.think-global.com.
All rights reserved. No part of this manual may be
reproduced, processed or distributed in any form (print,
photocopy, microfilm or any other process) or processed
by an electronic system without prior written permission
from the manufacturer.
We reserve the right to make changes according to technical
progress. Belinea is an internationally registered trademark.
Other brand names may be registered trademarks and must
be treated as such.
TABLE OF CONTENTS
INTRODUCTION
......................................................... 2
IMPORTANT INFORMATION
..................................... 3
CARING FOR yOUR LCD MONITOR
........................ 3
WALL MOUNTING
...................................................... 3
UNPACkING .............................................................. 4
CONNECTING
........................................................... 4
STARTUP ................................................................... 4
CONFIGURATION
...................................................... 5
BASIC SETUP ............................................................ 5
IMAGE SETTINGS USING THE OSD MENU
............ 5
OSD MENU FUNCTIONS
........................................... 6
TROUBLESHOOTING
................................................ 7
TECHNICAL SPECIFICATIONS
................................. 7
DEFINITION OF THE MAxDATA WARRANTy
.........
8
Guide to symbols
The symbols below are used in this manual to indicate
where there is risk of injury or damaging devices or to
indicate especially useful information:
DANGER! Indicates risk of injury. When not
following instructions, severe injury or death
may result.
ATTENTION! Indicates possible damage to
devices. When not following instructions, devices
may be heavily damaged.
IMPORTANT! Indicates hints on operation and
other useful information.
We are all responsible for the environment: this manual was printed from front to back on paper
that was produced without chlorine.
Important Safety Instructions
Some Belinea monitor models come with 2 power cords.
Please ensure you use the UK plug (3 pin) in the UK and
not the European plug (2 pin).
Do not place the monitor in very hot or cold, nor damp or
dusty surroundings. Do not put vases etc. on the monitor,
water may cause short circuits. Do not block or cover the
ventilating openings. All products that produce magnetic
fields, i.e. laser printers, loud-speakers etc., must not be
placed close to the monitor. Do not install this monitor
in areas where too much light or sunshine might directly
hit the screen, otherwise the brightness of the picture
will be poor due to reflections. Refer all servicing and
maintenance to authorised service personnel only!
CAUTION
Do not remove the cover!
Serious electrical shock hazards exist inside
this monitor.
NOTE
Removal of cover invalidates your warranty.
Information about Environ-
mentally Sound Waste
Management
Belinea monitors are designed to be environmentally
sound according to TCO guidelines. Please direct any
questions you may have regarding the disposal of your
monitor to our European waste management affiliates:
www.belinea.com/service/recycling
